Post: #1

Hey all,

I was just delabeling all of my products from prying eyes, and I noticed that my wolf was about half of where it was at a couple of days ago. It was leaking. I promptly transferred the Wolf dropper type into 2 10ml sprayer bottles, but I accidentally wasted a good amount of product when I tryed to spray it because it came out as a stream.

And idea on how I can make it actually spray? Can I just add water

Post: #2

Alcohol would be safer.
Water is rarely pure and introduces unknown contaminants which react in unknown ways. Google "water ruin whiskey"
Pure water (distilled) is as bad and sometimes worse.
Distilled water even dissolves ITSELF!! (but not oils very well)


Water also has a higher surface tension so is harder to atomize, again giving the nod to alcohol.

Post: #3

def not water man. use some ethanol. PA would be best but if you dont have any you could thin it out with some everclear

just remember you are in fact diluting it and also reducing longevity. On the pos tip, you will diffuse the shit out of wolf and it will project farther and hit harder

Post: #4

(11-07-2012 12:43 AM)John Schlongfellow Wrote:  Alcohol would be safer.
Water is rarely pure and introduces unknown contaminants which react in unknown ways. Google "water ruin whiskey"
Pure water (distilled) is as bad and sometimes worse.
Distilled water even dissolves ITSELF!! (but not oils very well)


Water also has a higher surface tension so is harder to atomize, again giving the nod to alcohol.

Yeah that's what I figured. I got very close to diluting it with water, which would have been very bad.

(11-07-2012 3:09 AM)thundr Wrote:  def not water man. use some ethanol. PA would be best but if you dont have any you could thin it out with some everclear

just remember you are in fact diluting it and also reducing longevity. On the pos tip, you will diffuse the shit out of wolf and it will project farther and hit harder

Yeah, I know I'm reducing longevity, but I think I'm willing to take that chance. Especially since half of it is already leaked.. might as well try something new. How should I go about diluting it. I'm not quite sure. What is PA btw?

I'm thinking of using ethanol/everclear and just using a dropper to do it. Probably just look for the consistency change, right? What sucks is that I'll have to use a couple of 10ml atomizers, but they're all sitting there anyways, might as well make use of em.